[an error occurred while processing this directive] [an error occurred while processing this directive]

Consistent Units of Measurement

Units

Ingeania uses consistent units of measurement. The default units used are SI units, i.e. metres (m) for length and kilograms (kg) for mass, with associated derived units. The unit systems shown in the table below are all supported.

PROPERTYSYSTEM OF UNITS
SICGSMPA BFTBIN
Masskggtonnesluglbf sec2 in-1
Lengthmcmmmftin
Timessssecsec
TemperatureKKK°R°R
Velocitym s-1cm s-1mm s-1ft sec-1in sec-1
Accelerationm s-2cm s-2mm s-2ft sec-2in sec-2
ForceNdynNlbflbf
MomentN mdyn cmN mmft lbfin lbf
PressurePaBaMPalbf ft-2psi
Densitykg m-3g cm-3tonne mm-3slug ft-3lbf sec2 in-4
EnergyJergmJft lbfin lbf
Heat FlowWerg s-1mWft lbf sec-1in lbf sec-1
Heat FluxW m-2erg s-1 cm-2mW mm-2ft lbf sec-1 ft-2in lbf sec-1 in-2
Film CoefficientW m-2 K-1erg s-1 cm-2 K-1mW mm-2 K-1ft lbf sec-1 ft-2 °R-1in lbf sec-1 in-2 °R-1
Heat GenerationW m-3erg s-1 cm-3mW mm-3ft lbf sec-1 ft-3in lbf sec-1 in-3
ConductivityW m-1 K-1erg s-1 cm-1 K-1mW mm-1 K-1ft lbf sec-1 ft-1 °R-1in lbf sec-1 in-1 °R-1
Specific Heat CapacityJ kg-1 K-1erg g-1 K-1mJ tonne-1 K-1ft lbf slug-1 °R-1in lbf lbf-1 sec-2 in °R-1
Dynamic ViscosityPa sBa sMPa slbf ft-2 secpsi sec
[an error occurred while processing this directive]